The non-stored writing speed is 450 cm/sec. The stored writing speed is 1 cm/sec.
Regarding the 7514, Ron Barrett WB7PMP says:
I used to work at Tek and took the opportunity to purchase a 7514 from Tek Surplus in 1978. I have used it on and off over the years and it has never quit. The 7514 was the pinnacle of the original generation 7000 series. As I found out from it's project manager and my division engineering manager at the time it pushed design to the limit in two areas. The basic electrical and mechanical design was based on the 7504 which is a real boat-anchor. In order to supply the additional power for storage and to reduce weight, one of the first switching power supplies to appear in test and measurement equipment was designed. This was a nontrivial achievement in the late 60's. The resulting design with some modifications was used for all subsequent 7000 series mainframes. When combined with the goal to not degrade 7504 on-screen performance, elevated storage with split-screen capabilities and every storage function imagined at the time made electrical design difficult and CRT design nearly impossible. Lesson learned: future generations of Tek CRT storage did not try to serve all needs. So the 7514 is somewhat unique, was very expensive and had a relatively short life in production as Tek rushed to introduce second generation products which were cheaper to produce. No more gold circuit boards like those used in the 7514. There have been a few of these pop up on E-bay but none have approached the condition of this one. I completely calibrated it several years ago and checked it out just prior to listing. As you can see from the photos, storage works fine and non-store rise time is about 3ns with very clean transient response. Measured bandwidth was 108 MHz and would be more if the spec. on aberrations was pushed to the limit. Spot size, trace noise and writing rate are what one would expect.
The inverter control circuit in the 7514's switch-mode power supply is made of discrete components. It does not use the 155-0067-02 inverter control IC that is featured in most 7000-series mainframes.